This practice is used to determine the LR of specified glass types and constructions exposed to uniform lateral loads. Use of this practice assumes: The glass is. Historical Standard: ASTM Ea Standard Practice for Determining Load Resistance of Glass in Buildings. SUPERSEDED (see Active link, below). ASTM Ea. Standard Practice for Determining Load Resistance of Glass in Buildings. Available for Subscriptions. Content Provider ASTM International.
|Published (Last):||4 May 2007|
|PDF File Size:||4.81 Mb|
|ePub File Size:||10.1 Mb|
|Price:||Free* [*Free Regsitration Required]|
It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. D Practice for Plastics: Today, some 12, ASTM standards are used around the world to improve product quality, enhance safety, facilitate market access and trade, and build consumer confidence. Copyright Compu-tecture, Inc.
ASTM E Determining Load Resistance of Glass in Buildings
Nails, Spikes, and Staples. For conversion of quantities in various systems of measurements to SI units, refer to SI For conversion of quantities in various systems of measurements to SI units, refer to SI This standard does not purport to address all of the safety concerns, if any, associated with its use.
The values given in parentheses are for information ast.
ast The values stated in SI units are to be regarded as the standard. The final thickness and type of glass selected also depends upon a variety of other factors see 5.
If you like to setup a quick demo, let us know at support madcad. Powered by Standards Documents. Click here to download full list of books. Appendix X1 and Appendix X2 provide additional procedures to determine maximum lateral deflection for glass simply supported on four sides.
Remember me for one month.
This practice assumes that 1 the supported glass edges for two, three, and four-sided support conditions are simply supported and free to slip in plane; 2 glass supported on two sides acts as a simply supported beam; and 3 glass supported on one side acts as asgm cantilever. Work Item s – proposed revisions of this standard. E Terminology of Building Constructions.
Sign In or Register.
Search book title Enter keywords for book title search. New Products – more.
ASTM E1300 Standard Practice for Determining Load Resistance of Glass in Buildings
Land Use and Development. Uniform Plumbing Code, 8th Printing. F Standard Specification for Driven Fasteners: Enter your personal account email address to request a password reset: This practice applies to vertical and sloped glazing in buildings for which the specified design loads consist of wind load, snow load and self-weight with a total combined magnitude less than or equal to 10 kPa psf.
Determination and Report of Procedures. Are you sure you want to empty the cart? The final thickness and type of glass selected also depends upon a variety of other factors see 5. Appendix X3 presents a procedure to compute approximate probability of breakage for annealed AN monolithic glass lites simply supported on four sides.
There were no books found for the applied search filters.
This practice does not apply e300 any form of wired, patterned, etched, sandblasted, drilled, notched, or 0a9 glass with surface and edge treatments that alter the glass strength. C Standard Specification for Flat Glass. Link to Active This link will always route to the current Active version of the standard. This practice addresses only the determination of the resistance of glass to uniform lateral loads. D Practice for Plastics: Appendix X4 lists the key variables used in calculating the mandatory type factors in Tables and comments on their conservative values.